Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
MOUNTING THE CHARGER
The charger can be mounted in any position.
Use the 4 screws provided to safely secure charger to mounting surface.
Use caution to not over-tighten mounting screws.
The charger housing is not weatherproof or submersible.
Care should be taken to locate the charger in a clean, dry place.
INSERTING LANTERN IN CHARGING BASE
The charger is equipped with two prongs that align with notches in the base of the lantern.
Simply align these parts and apply minimum force to slide the lantern back into the charger until
the lantern latches into the charger base.
Using excessive force while inserting lantern may cause damage to charger.
LIFETIME LIMITED WARRANTY
The case, switch, and internal parts, excluding the lens, lamp rechargeable Li-ion battery pack and
charger, have a lifetime limited warranty from date of purchase. Should your unit fail to operate for any
reason, contact our authorized service center, Larson Electronics for further instruction at 1-800-369-
6671. We will repair and replace the warranted defective parts without cost and return the unit to you.
The rechargeable Li-ion battery pack and charger are warranted for a period of one year in accordance
with the above term. This warranty does not apply to misuse or abuse.
CHARGING OPTIONS
WARNING:
Use only adapter supplied with charger. Use of any other adapter may cause damage to the
charger and lantern.
The RUL-9 can be charged using the supplied 120 VAC wall adapter plug or by direct wiring to a 12-24
VDC power source (not supplied). For the direct wire option, the wire and co-axial jack from the wall
plug adapter can be cut off and used to make connections to the charge base. When mounting in any
vehicle, please have product professionally installed to prevent any safety hazards, personal injury and
possible damage to vehicle or product. The positive lead wire from a 12-24 VDC source must be
connected to the center terminal of the co-axial jack. The negative lead wire from the 12-24 VDC source
must be connected to the center terminal of the co-axial jack. It is recommended that a 5 amp, time
delay fuse be connected in a series to the positive lead of the DC power supply before the co-axial jack.
