P A G E 4
PREPARING THE SCREEN CASSETTE
Insert
F-End Cap with Spring
into the correct end of the
A-Screen Cassette
Assembly [Fig 2A]
(the assembly will only fit correctly in one end). Make sure to
line up the spring and bushing notches with one of the small slots in the center
screen tube. Wind the spring clockwise the number of turns designated in the fol-
lowing chart and push the
F-End Cap with Spring
in place on the
A-Screen Cas-
sette Assembly
. A rubber mallet is helpful to fully seat the
F-End Cap with Spring
.
Note that the spring in the cassette is for tension only. You will need to raise and
lower the screen by using the
G-End Cap Chain
.
SIDE VIEW
HEAD
OUTSIDE
INSIDE
I-Recess Mount Clip
OPENING WIDTH
36”- 72”
73”-120”
120”-140”
140”-192”
SPRING TENSION
25
30
35
40
OPPOSITE END OF CARTRIDGE
Test
Chain Guide
for smooth operation. If it’s too tight, loosen allen screw. Insert
the
G-End Cap with Chain
into
A-Screen Cassette Assembly
and push into place.
The
G-End Cap with Chain
is setup for internal operation (operating from one
side). If desired this can be disassembled and altered to allow for either internal or
external operation
[Fig 2C].
Slide one piece of the
J-Weatherstrip
into bottom slot of
D-Pull Bar
and the other
piece into the top of
A-Screen Cassette Assembly
. The O-Weight Bars are already
inserted inside the hollow of the D-Pull Bar. Now insert the
E-Pull Bar End Caps
into ends of
D-Pull Bar [Fig 2B]
.
MOUNTING THE SCREEN CASSETTE
Mount the
I-Recess Mount Clips
to the inside of opening
.
When installed, the clips
should be centered above the cassette. Install a
P - #8x1”(25mm) Panhead Screw
into the center of the slot to allow front to back
adjustment
[Fig below]
.
Snap the
A-Screen Cassette Assembly
into place. Secure the
A-Screen Cassette Assembly
in place by screwing the
F-End Cap
and
G-End Cap
to the side jamb of the opening. The I-
Recess
Mount Clips
and
A-Screen Cassette Assembly
may be reversed
to face toward the inside or outside of an opening depending
upon which side the Pull Chain needs to be accessible. See image
2C
for optional user performed Pull Chain routing options.
NOTE:
the
I-Recess Mount Clips
lower the
A-Screen Cassette
Assembly
in the opening by 1/4”. The same 1/4” gap should be
left above the
F & G-End Caps
to avoid bowing the cassette.
D
A
J
J
E
E
O
F
A
2A
2B
2C
INTERNAL OR
EXTERNAL OPERATION
(OPTION SET-UP
PERFORMED BY USER)
INTERNAL OPERATION
(STANDARD)
ESCAPE 800
INSTALLATION INSTRUCTIONS
RECESS INSTALLATION
