EPL-MJ-XXW-LED Series
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
have been joined together, use the other gasket to seal between the elbow extension and the top of the light fixture, and
secure it using the provided hardware kit. There should be one screw and one lock washer for each hole. Be sure to pull
wiring through the elbow extension and into the junction box, and be sure both gaskets stay in place and provide a good
seal once the screws are secure.
Wiring
We strongly encourage a licensed electrician install this product,
in all locations, especially in outdoor areas where
weatherproofing may be required.
Warning:
Check product label for correct input voltage!
Secure each pair of wires according to the diagram. Utilize the junction box or
similar device and take precautionary steps for weatherproofing all connections
if installed in a location where water may come in contact with the unit. Ensure
the unit is properly grounded and that wiring is done according to all local and
national electrical/building codes. Unit is "instant on" and will illuminate as soon
as power is supplied.
M
aintenance
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
•
Disconnect power running to the lamp and be sure the fixture is cool to the touch.
•
Use a non-abrasive glass cleaning solution to clean the lens.
Note: It is not necessary to open the fixture and clean or touch the LED’s.
Change Steady/Strobe Setting
In order to switch light settings between steady burn and strobe,
you will need to access the board of the light by opening the
back of the unit
as shown
. Once the board is accessible, locate
the small switch and change to the desired position.
Be sure
flamepath is free from damage or debris and light is sealed
again properly before operation.
Use and Care
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
Replacement Parts
The EPL-MJ-XXW-LED series is designed to provide years of reliable performance. Should the need for replacement parts
arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION
REQUIREMENTS. SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON
ELECTRONICS BY EMAIL AT
OR BY PHONE AT
1-877-348-9680
FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
