Ver.0118-1
SOL240-2XWP50E-2X200A-RMBB-DNS-7.63SQ
Larson Electronics LLC
2
CONTROL BOX
Place the control box at the base of the pole.
Move the power switch to its
ON
position to power the internals. Make sure
all breakers and switches are moved to the
ON
position at this time. This will
enable power to your attached devices and allow the solar panels to begin
charging the batteries.
MAINTENANCE
If the lens or solar panel becomes dirty, wipe down with a mild soap and
water solution.
Keep snow and debris clear of the solar panel so the batteries can charge. If
the panels are covered by snow or debris for an extended period of time,
allow the battery to charge in full direct sunlight for at least 5 hours for the
battery to reach its full capacity.
It is recommended to occasionally inspect the unit for any defects.
TROUBLESHOOTING
If for any reason the LED beacon does not power on:
Batteries not fully charged:
Make sure the fixture is placed in an
area where the solar panel gets the maximum amount of full, direct
sunlight every day. If the solar panel does not receive enough sunlight
during the day (e.g. due to cloudy or overcast weather conditions), it
will be recharged on the next sunny day and resume operation.
Other light sources:
(For units equipped with a day/night sensor.) If
your solar light is located too close to street lights, porch lights or
other lights, the solar panel may turn off the fixture. Relocate the solar
panel or eliminate those other light sources.
Not enough direct sunlight:
Ensure that the fixtures are not installed
in a shady area, for example, in the shadow of a tree or a house. If
necessary, move the fixtures to an area that gets full direct sunlight.
Switch is in the OFF position:
(For units equipped with a power
switch.) Cycle power button in a dark room. The light(s) should come
on when the switch is in the on position if the unit is fully charged.
9419 US-HWY 175
Kemp, TX 75143 USA
P:
800-369-6671 | INTL: 903-498-3363 F:
903-498-3364
www.larsonelectronics.com
