SLEDB-110V-MS-PA
Larson Electronics, LLC
Phone: (
877
)
348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
5
INSTALLATION
This unit comes pre-assembled with the selected color from factory. Follow the steps below for installing and
maintaining the strobe light.
MOUNTING
Mounting is provided by a heavy gauge aluminum back plate fabricated from copper free aluminum with six
pre-drilled holes designed to be bolted to walls, ceilings and flat surfaces for permanent and secure attachment.
WIRING
We strongly encourage a licensed electrician install this product, especially in outdoor locations where
weatherproofing may be required. Voltage driver permits operatio
n at
110
V
AC
.
W
arning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture
wires as shown in the diagram
Take precautionary steps for weatherproofing
all
connections if installed in a location where water may
come in contact with the unit. Ensure the unit is properly
grounded.
The SLEDB-110V-MS-PA from Larson Electronics is an LED Motion Alarm System w/ Horn for industrial use. This unit
features a Class II LED strobe light and audible horn that can produce eight different tones to sound levels up to
110dBA @ 10 feet. A pre-drilled aluminum base facilitates wall, ceiling or surface mounting applications.
HORN
Selectable by switch on sound module.
1. Continuously running train of eight sounds in sequence.
2. Wail - Conventional Siren
3. Yelp - Rapid Siren
4. Two-Tone
5. Whoop - Ascending Low to High
6. Yeow - Descending High to Low
7. Horn - Steady
8. Beep - Slow Intermittent Horn
9. Stutter - Rapid Intermittent Horn
10. Remote - Enables Remote Selection of:
a. 7 - Horn
b. 4 - Two-Tone - Alternating
c. 3 - Yelp - Rapid Siren
d. 1 - Wail - Manual Siren
