RUL-9
Series
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
3
INSERTING LANTERN IN CHARGE BASE
The charger is equipped with tow prongs that align with notches in the base of the lantern. Simply align
these parts and apply minimum force to slide the lantern back into the charger until the lantern latches into
the charger base. Using excessive force while inserting lantern may cause damage to charger.
LIFETIME LIMITED WARRANTY
The case, switch, and internal parts, excluding the lens, lamp rechargeable Lithium-ion battery pack and
charger, have a lifetime limited warranty from date of purchase. Should your unit fail to operate for any
reason, contact our service center, Larson Electronics for further instruction at 1-800-369-6671. We will
repair and replace the warranted defective parts without cost and return the unit to you. The rechargeable Li-
ion battery pack and charger are warranted for a period of one year in accordance with the above term. This
warranty does not apply to misuse or abuse.
CHARGING OPTIONS
WARNING:
Use only adapter supplied with charger. Use of any other adapter may cause damage to the
charger and lantern.
The RUL-9 can be charged using the supplied 120 VAC wall adapter plug or by direct wiring to a 12-24 VDC
power source (not supplied). For the direct wire option, the wire and DC (male) power jack from the wall plug
adapter can be cut off and used to make connections to the charge base. When mounting in any vehicle,
please have product professionally installed to prevent any safety hazards, personal injury and possible
damage to vehicle or product. The positive lead wire (+) from a 12-24 VDC source must be connected to the
center terminal of the male power jack. The negative lead wire (-) from the 12-24 VDC source must be
connected to the outer terminal of the male power jack. See figure 1 below. It is recommended that a 5 amp,
time delay fuse (not supplied) be connected in a series to the positive lead of the DC power supply before the
male power jack.
FIGURE 1