3
www.
.com
By default, the Setup Wizard will open automatically.
Important Notes for using the Wizard:
•
Password
Strong
” administrator user password. Follow the on-screen
NOTE
: There is no factory default
password for this device.
•
Date and Time
•
Storage - HDD
with it in this window. If you installed an HDD or replaced the HDD, that HDD needs to be initialized by the recorder before it can be
used to record data. Select (check the box for) that HDD, then click
Init
to initialize the disk.
NOTE
:
Init
will erase all data from the
disk and can take several minutes to complete. When the initialization is complete, click
Next
to continue.
•
Network Settings
: By default, the recorder acquires it’s network settings using DHCP (dynamic network settings). Depending on
un-check the
Enable DHCP
option in the network setup menu, and then click
Apply
.
Step 9. Access the Menu system
functionality of the system. To use most menus, the user must log into the NVR system, either locally or remotely, with administrative
privileges. To open the Menu system from the Live View screen, right click anywhere in the screen, then select
Menu
.
Step 5. Install a monitor, mouse, power
For the following steps, refer to the back panel photo above for the location of connectors.
1.
Install and setup your monitor in accordance with the instructions provided with the monitor. Do not power it on at this time.
2.
Cable the HDMI or VGA connector to your monitor’s VGA or HDMI input. The HDMI interface provides the best performance.
3.
Plug the mouse into the USB connector on the front or back of the NVR.
4.
your local area network (LAN) into the RJ45 LAN connector on the back of the NVR.
5.
Connect the power cord (or power adapter for NVR-POE only) to the power connector on the back panel of the NVR, and then into a
UPS (recommended) or surge protector.
Step 6. Install cameras
Install your security cameras. Always follow the installation instructions provided with the camera.
NOTE
: If the cameras feature Power over
Ethernet PoE), the cameras that plug into the ports on the back of the NVR can be powered through those ports.
Step 7. Connecting it together – initial system setup
1.
Plug the Ethernet drop cables from the cameras into the RJ-45 Ethernet Switch Ports on back of the NVR.
2.
Power on your cameras.
3.
4.
Power on the monitor.
NOTE
display the input connected to your NVR (HDMI or VGA).
Step 8. Use the Wizard for basic c
n setup
Power on the NVR. Normally, an splash screen appears within 2 minutes.
Default Password:
ChangeMeN w
Password _____________________________________
(Write New Password Here)