Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
NSR-9850
OPERATING INSTRUCTIONS
Thank you for selecting the NSR-9850. Save this manual. Please read this manual before using this
product. It includes important safety and operation information. Be sure to charge the light fully before
first use. A battery is fully charged when the charger light is green.
CHARGING
Fully charge this light before the first use. If the battery is new or has been unused for several months,
several charge and discharge cycles may be needed to reach full battery capacity. To reach maximum
performance, run the light to completely discharge the battery and then recharge. Each charge cycle
will extend the operation time until maximum capacity is achieved. The charge time for maximum
capacity is approximately 3 hours.
Use only the supplied charge platform, battery and AC or DC adapter. The maximum allowable DC input
is 15VDC.
For best performance, charge the light when the LED’s start to dim.
Connect the AC power adapter to the charging platform. The green indicator will light.
With the floodlight facing forward, slide the light into the charging platform until the contacts
snap into place.
The red light on the charging platform indicates the light is properly inserted into the charging
platform and charging. The light remains red until the battery is fully charged. At full charge,
the light turns green. The total time to full charge varies depending on the remaining charge in
the battery pack.
The charging platform provides a trickle charge to a fully charged battery pack.
Runtime: Flashlight or floodlight up to 9 hours, dual-light 4 hours, flashlight strobe or floodlight
strobe 24+ hours, flashlight strobe with constant floodlight 7 hours.
SAFETY
CAUTION: Bright LED radiation: Avoid direct eye exposure. This is a Class 2 LED product per IEC 60825-1
Edition 1.2.2001.
DO not use or charge this light in explosive or hazardous areas.
Do not attempt to repair or disassemble the light, the charger platform, battery or the power
supply.
Use only the charging platform, AC or DC adapters and battery pack that is supplied with the
light.
