IND-MD-DF-ESF-R1-SP0015
Replacement Sprayer Wand for IND-MD-DF-ESF-R1 Electrostatic
Sprayer
Instruction Manual
Thank you for your purchase of the Larson Electronics
IND-MD-DF-ESF-R1-SP0015
Replacement
Nozzle Cone for
Threaded Nozzle for IND-MD-DF-ESF-R1 Electrostatic Sprayer
. Please read these instructions and entirely and
familiarize yourself with operations and maintenance practices pertaining to this product before operating. Keep
these instructions for future reference, should you need them.
Warnings and Safety
•
This sprayer should only be operated and maintained by someone who is familiar with it's operation and
correct maintenance practices as outlined in this manual.
•
Larson Electronics is not liable for decreased reliability, damages, or injuries due to improper
maintenance or modifications to the sprayer.
•
Be sure the lid is completely tightened before operating.
Spillage could be poisonous
and cause skin
irritation or other injury. Clean the outside of the tank if any spillage occurs, and immediately clean skin if
you come in contact with the chemicals inside.
•
WARNING:
BE SURE TO INSTALL GREEN GASKET BEFORE USE OF UNIT
. Refer to Operation
Section for installation instructions.
•
Wear eye protection and gloves when filling the sprayer,
avoid contact with skin and eyes
while filling
and during operation.
•
Liquids being put into the tank must be filtered clean of particles in order to keep the nozzle from
becoming clogged.
Do not use powders
in the tank as this will cause buildup and clog the nozzle. If
using soluble solutions, mix them outside the tank and then filter before pouring into the tank.
•
ALWAYS REVIEW THE SAFETY INFORMATION AND WARNINGS FOR THE CHEMICALS USED IN
THIS SPRAYER.
Larson Electronics is not responsible for any injury associated with the chemicals used
in the sprayer. Avoid using chemicals that are corrosive to metal or plastic. Always wear protective
equipment to avoid ingesting or coming into contact with harmful chemicals.
•
Do not
use this sprayer in an explosive or flammable environment.
•
Always keep the sprayer dry and clean
. Do not submerge in water or use in overly wet location to
protect the motor and electronics from water damage.
•
The use of strong acids or bases is prohibited
. Other chemicals should be used in accordance with
manufacturer instructions and safety warnings.
•
Battery contains high voltage,
DO NOT
disassemble the sprayer yourself as electric shock could occur.
•
Avoid contact with other persons during operation. Avoid touching the spray rod and charging port during
operation.
•
Place a megaohmmeter in the area needing to be tested to make sure you have a true earth ground.
•
Avoid all possible insulators
:
o
Do not wear insulated or rubber shoes. We recommend leather soles.
o
Do not stand on paper unless it is conductive.
o
Make sure the floor is clean and dry. Any
liquid
overspray on the ground can act as an insulator.
•
It is recommended to use a grounding strap. If using a grounding strap, make sure to always wear it
during operation. These are not included with unit.
•
Grounding straps can be connected to the unit by
connecting
to the cable attachment found on
the side
of
the unit.
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
