GSLEDIP6-C1D2
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
4
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
Negative
-
-
Positive
+
+
Black
White
Features
4 Watts
12V DC or 24V DC Model
100,000 Life Expectancy
Options
Voltage:
12V DC @ 0.
33
amps
OR
24V DC @
0.
16
amps
Check product label for correct voltage.
The Larson Electronics GSLEDIP6-C1D2 is a low voltage hazardous location lighting solution approved for Class1
Division 2 environments and U.L. 1598 compliant for use in wet locations. This powerful LED strip light produces 221
lumens, operates from 12 or 24 VDC, and is suitable for a variety of applications.
WIRING
These hazardous location LED lights are equipped with 5 feet of cord containing a standard two wire (White+ Black-)
connecting configuration. These lights are not multi-voltage; each light is preconfigured for 12 or 24 volt DC current at 4
watts .33 amps on 12 VDC and .16 amps on 24 VDC.
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at 1
2-14V DC.
Make sure that the power is disconnected before installing. This fixture is extremely heavy and must be mounted to a surface that
can structurally support the load.
Do
NOT
let fixture hang on one bracket at any time. Failing to comply can result in breakage of end casting or mounting bracket,
allowing the fixture to fall, which can cause serious injury or death.
Only use lamp size, type and/or wattage as shown on fixture nameplate.
II.
Ratings
Class I, Division 2 Groups A, B, C, D
CSA 22.2 No. 250.0
1598
IP54 Ingress Protection
T3 Temperature Ratings
