GL-3000-24-M
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
3
Golight GL-3000-24-M 24 Volt Wireless Remote
Control Spotlight -hand remote-Magnetic Base
Instruction Manual
GOLIGHT
The Golight Stryker is designed to magnetically attach to a vehicle. The 2-Speed Searchlight with Directional Flexibility is
controlled by a wireless remote, which gives the operator a full 370° horizontal rotation and a 135° vertical tilt with fingertip
control.
The StrykerTM Includes:
•
StrykerTM Searchlight
•
Remote Control
•
2 GP Super Alkaline Batteries 23A 12V
•
Rockguard
•
Magnectic Base
ASSEMBLY
WARNING:
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
CRITICAL SAFETY INSTRUCTIONS:
•
INSTALLATION SHOULD ONLY BE CONDUCTED BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH NEC AND ANY
RELEVANT LOCAL BUILDING CODES.
•
RISK OF FIRE OR ELECTRIC SHOCK. FIXTURE INSTALLATION REQUIRES KNOWLEDGE OF LUMINAIRES ELECTRICAL
SYSTEMS. IF NOT QUALIFIED, CONTACT A QUALIFIED ELECTRICIAN.
•
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
MAKE SURE THE SUPPLY VOLTAGE IS THE SAME AS THE RATED LUMINAIRE FIXTURES VOLTAGE.
•
TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR SHARP
OBJECTS. SUITABLE FOR DAMP LOCATIONS.
MOUNTING
Select the best location on your vehicle for the magnetic mount Stryker. Make sure the metal area under the magnetic
base is flat and clean to ensure a strong bond.
Route the power cord into the vehicle through a door frame and connect to 12V power outlet.
The magnetic mount Stryker should be removed from vehicle’s exterior while traveling at excessive speeds and in
strong wind conditions.
Each spotlight needs to be wired on a single dedicated circuit and the power fused at 10 amps. With the power
connected, your light is ready for operation.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Golight Stryker is controlled with a programmable remote with 6561 different channels. This feature allows you the
freedom to change the channel selection, and the receiver relearns the new selection.
PROGRAMMING THE TRANSMITTER
This light has been pre-programmed at the factory, and it is not necessary to re-program the transmitter, unless you
experience outside interference.
1. IMPORTANT: Disconnect power by removing fuse or disconnecting vehicle battery.
2. Remove battery cover from remote control.
3. Set the 7 dip switches to a selection of your choice. There are 3 positions on each; positive, negative and neutral.
Use a small screwdriver and select a position for each dip switch. *Please note that the orientation of the +/- switch
positions may vary among different models of wireless remote controls.
4. Insert both GP 23A 12V batteries. Be sure batteries have adequate charge.
