GAU-PT-150LTL-LED-480V
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
INSTALLATION
We strongly recommend only a licensed electrician install this product.
Make sure power is disconnected prior to installing. Fixture must be
mounted to a surface that can structurally support the load.
The fixture is supplied with the desired beam config, light color and voltage.
A 2.5’ whip is already affixed to the housing for wiring.
Mount following the steps below:
1.
Turn off power at electrical panel
.
2.
Mount light by its trunnion mount to pole. The LED wall pack ships
with your selected pole mount size.
3.
Loosen hand screw and mount to pole capable of holding its weight.
Tighten hand screw to secure to pole. Plan a way for wiring to
connect such as using a separate junction box and run power to the
CORRECT VOLTAGE
.
4.
Adjust lamp vertically by loosening hex bolts on either side.
5.
Swing lamp into final position and tighten any loose bolts.
6.
Wire the whip/power cord to existing power source. Follow proper
steps to weatherproof electrical connections as necessary.
7.
Turn power on.
This light is “instant-on” and will illuminate once power is supplied to
the unit.
ADJUTMENT BOLTS
Voltage:
120-277V AC
Amps:
1.25A @ 120V, 0.625A @ 240V, 0.54A @ 277V
HAND
SCREW
MOUNTING
The GAU-PT-150LTL-LED-480V pole top slip fit mount LED light features an adjustable swivel bracket constructed of 3/8"
aluminum that allows over 270° of adjustment and is attached to a slip fit yoke for easy installation. The slip fit yoke is built to
customer`s specs, enabling operators to mount this LED light to their specific pole size. For example, selecting a 2" OD
mount means that the yoke mount will fit onto pipes or bull horns with a 2" OD. The entire selection of outside diameters is
listed below in the specifications section.
MAINTENANCE
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
•
Disconnect power running to the lamp and be sure the fixture is cool to the touch.
•
Use a non-abrasive glass cleaning solution to clean the lens.
Note: It is not necessary to open the fixture and clean or touch the LED’s.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
GAU-PT-150LTL-LED-480V
is designed to provide years of reliable performance. Should the need for replacement
parts arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
