GAU-125V-20A-P
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
GENERAL INFORMATION
Open plug by removing the two screws on front. Remove top cover and wire accordingly. Once connected, replace top
cover.
CAUTION:
Disconnect power before installing. Never wire energized electrical components.
1.
NOTICE:
For installation by a qualified electrician in accordance with national and local electrical codes and the
following instructions.
2.
CAUTION:
RISK OF ELECTRIC SHOCK. Disconnect power before installing. Never wire energized electrical
components.
3.
CAUTION:
USE COPPER CONDUCTORS ONLY.
4.
Check that the device’s type and rating are suitable for the application.
5.
Select conductors having 90°C or higher rated insulation having sufficient ampacity in accordance with the 60°C
column of National Electrical Code Table 310-16 or Canadian Electrical Code.
6.
Wiring Instructions
a.
Strip conductors using strip gauge on plug. If plug does not have a strip gauge, then strip conductor 1
inch (25 mm). DO NOT TIN CONDUCTORS.
b.
Loosen terminal screws. Insert conductors fully into proper terminals per Table 1 and center under
terminal screw.
Table 1
TERMINAL
CONDUCTOR
Green, Grid, G,
Equipment grounding conductor,
(bare, green or green/yellow)
White, W
NEUTRAL (White or Gray)
Black, Brass (Other
Than White or Green)
HOT terminal (NOT White NOT
Green)
c.
TAKE EXTREA CAUTION THAT THERE ARE NO LOOSE STRANDS.
d.
Tighten terminal screws.
MAINTENANCE
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
•
Disconnect power running to the
unit
and be sure the fixture is cool to the touch.
•
Use a non-abrasive glass cleaning solution to clean the
unit
.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
GAU-125V-20A-P
is designed to provide years of reliable performance. Should the need for replacement parts arise,
please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
