II. Rechargeable Battery Replacement
2
I. Battery Replacement
1. Loosen the locking screw located on the
side of the lens cap.
CAUTION: Do NOT
attempt to completely remove the locking
screw. Doing so is not necessary and may
damage the threads. The screw simply needs
to be loosened enough to allow the lens bezel
to unscrew.
2. Unscrew the lens bezel from the housing in
a counter-clockwise direction.
3. Loosen each of the two Charger Contact
Pins located below the Floodlight Lens.
These two Screws should be loosened until
approximately 1/8” of thread is visible.
CAUTION: Do NOT attempt to completely
remove either of these two screws.
Doing so is not necessary and will potentially
damage the light’s ability to charge.
The two screws simply need to be loosened
enough (approximately 1/8”) to allow the
reflector / circuit assembly to be removed.
4. Turn the light upside down and carefully
shake the light in order to remove the reflector
/ circuit assembly. Allow the reflector / circuit
assembly to slide into your hand.
CAUTION:
Do NOT touch the reflector surface with your
finger. Doing so may damage the reflector
surface.
5. Next, allow the rechargeable battery pack
to slide out of the light paying close attention
to the battery pack’s orientation within the
handle.
6. Using only the approved replacement
rechargeable battery pack, slide the new
battery pack into the handle of the light using
the directional arrow marked on the side of the
pack to be a guide to proper battery orientation.
7. Align the reflector / circuit assembly so that
the switches on the assembly are aligned with
the switches on the housing. Carefully insert
the assembly back into the flashlight housing
until it is fully seated in the housing. CAUTION:
Be careful to not touch the reflector surface with
your finger. Doing so may damage the reflector
surface.
8. Tighten both of the Charger Contact Screws
until they are fully seated. CAUTION: Do NOT
over-tighten these two screws. Doing so may
damage the threads and impair the light’s ability
to properly charge.
9. Replace the lens bezel by screwing it onto
the housing in a clockwise direction.
10. Tighten locking screw.
CAUTION: Do NOT
over-tighten. Doing so may damage the threads
and impact the light’s Intrinsic Safety.
