EPL-SL-5X75-12V-TXF
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
1
USING THE HAND LAMP
1.
Position each light head in desired location using swivel hook.
2.
Attach power cord from lamp to
Voltage Specified on product label
.
WARNING:
Failure to connect proper voltage could cause damage to
fixture which may not be covered by warranty.
OPERATION
The LED lamp in each hand lamp is “instant-on” and will illuminate once power is supplied.
LAMP REPLACEMENT
1.
Loosen set screw.
⑧
2.
Unscrew Guard/Globe assembly
⑨
from handle assembly.
3.
Replace lamp with 75 watt(max) bulb for Group F & G locations or
10 watt(max) bulb for Group C and D locations.
4.
Inspect o-ring seal
⑪
. If worn or damaged, it must be replaced to
insure watertight seal.
5.
Screw globe assembly completely onto lamp base.
6.
Tighten set screw securely to 6 in-lbs.
Note:
Over tightening can deform threads.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this
device and could affect the life of the equipment. Always check for
damaged or worn out parts before using the device. Store it in a secure
place out of the reach of children when not in use. Inspect for good
working condition prior to storage and before re-use
.
REPLACEMENT PARTS
The EPL-SL-5X75-12V-TXF is designed to provide years of reliable
performance. Should the need for replacement parts arise, please contact
Larson Electronics
.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS
PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS. SHOULD
FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED,
PLEASE
CONTACT
LARSON
ELECTRONICS
BY
AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER
ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
Exp Cord Cap
Position device near work area for operation. Run cable to nearby power
source. Insert and twist-lock explosion-proof plug into a compatible receptacle
within the hazardous environment. See
plug operation
below.
PLUG OPERATION
Electrical connection between plug and compatible receptacle is accomplished
after plug fully inserts into receptacle and rotated clockwise.
1.
Lift receptacle door and locate polarization on mating plug pin and
receptacle face. Insert plug straight all the way into receptacle until it
cannot go further.
2.
Rotate plug clockwise limit (37º), this closes internal contacts and
completes circuit. This also mechanically locks plug into receptacle so it
cannot be pulled out.
3.
To remove plug, push plug inward and turn to counterclockwise, pull plug
straight out.