LT-3100S GMDSS User & Installation Manual Rev. 1.02
Web server
Lars Thrane A/S
www.thrane.eu
Page 51 of 71
Dashboard
The dashboard is showing details about the main units, which forms the Satcom system: the LT-3110S
Control Unit, the LT-3130 Antenna Unit, the LT-3140S Interface Unit, the LT-3150S Alarm Panel, and the LT-
3160S Printer Adapter. If the antenna unit is connected properly to the control unit, then the antenna unit
will be visible on the web server dashboard, as illustrated in Figure 42. Otherwise only the control unit will
be visible. For each unit, the following information will be available: unit number, unit name, unit part
number, unit serial number, and software version. The antenna unit will automatically be updated with the
software version, which is available in the control unit.
Software update
Carefully read the software release note, provided by Lars Thrane A/S, before software updating the LT-
3100S GMDSS system.
Navigate to the web server of the LT-3100S GMDSS system, by following the instructions in
built-in web server on page
Select the ‘Software update’ web
page and click the ‘Browse…’ button
to
select the LT-3100S GMDSS system file, which must be uploaded to the system. The LT-3100S GMDSS
software image has the following filename (example): LT-3100S-v1.01R-0005.lti
–
the software image and
release documentation will be available on the official company website: www.thrane.eu, under the
specific product. Finally,
click the ‘Upload’ button to start the upload of the new software
image. The
upload and installation of the software image will take a few minutes. Progress indication bars can be
monitored on the software update web page, while the software update is on-going. The LT-3100S GMDSS
system will reboot, once the software image is installed safely in all units.
NOTE
:
The LT-3110S Control Unit and the LT-3130 Antenna Unit must be operated with the same
software version. Automatically, software update will happen, if the control unit identifies
that the software version in the two units are different.
IMPORTANT
: Do not remove power from the control unit while the software update is on-going. Also, do
not disconnect the antenna cable between the control unit and the antenna unit, while the
software update is on-going.
Diagnostic report
A diagnostic report can be
downloaded from the webpage ‘Diagnostics’. Navigate to the webpage and
press the ‘download’ button. A file
with the following filename (example): LT-3100S_00000061_191115-
152149.tar.gz will be downloaded to a location selected by the user. The diagnostic report can be sent back
to Lars Thrane A/S in case of required support and assistance. The diagnostic report contains technical data,
from the LT-3100S GMDSS system, and will help identify and resolve problems at the installation site. This is
to avoid sending back the LT-3100S GMDSS system for unnecessary debug and repair, at the Lars Thrane
A/S facility.
Содержание iridium LT-3100S
Страница 2: ......
Страница 83: ...Lars Thrane A S Skovlytoften 33 2840 Holte Denmark www thrane eu...
