Preparation for Use
10. Refer all servicing to qualified service personal. Servicing is required when
the apparatus has been damage in any way, for example, when the
power-supply cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
11. The DC plug is used to disconnect the device, the disconnected device
should remain readily operable. In order to disconnect the apparatus from the
DC power completely, the DC plug must be removed from the AC outlet
completely.
Unpacking and Set Up
•Remove the Sound bar from the carton and remove all packing material from
the Sound bar. Save the packing material, if possible, in case the Sound bar
ever needs to be serviced or transported. The original carton and packing
material is the only safe way to pack your Sound bar to protect it from damage
in transit.
•Remove any descriptive labels or stickers on the front or top of the cabinet.
Do not remove any labels or stickers from the back or bottom of the cabinet.
•Place your Sound bar on a level surface such as a table, desk or shelf,
convenient to an AC outlet, out of direct sunlight, and away from sources of
excess heat, dirt, dust, moisture, humidity, or vibration.
•Unwind the Line cord connecting the AC adapter and extend it to its full length.
Protect Your Furniture
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on
your furniture. However certain types of oil based furniture polishes, wood
preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and
leave marks or a rubber residue on the furniture. To prevent any damage to
your furniture we strongly recommend that you purchase small self-adhesive
felt pads, available at hardware stores and home improvement center
everywhere, and apply these pads to the bottom of the rubber 'feet' before you
place the unit.
Power Source
This sound bar is designed to operate on normal DC Power source, it works
only under SMPS 110V-240V
～
50hz/60Hz. Do not attempt to operate the
Sound bar on any other power source. You could cause damage to the
Sound bar that is not covered by your warranty.
- 3 -
