Larius TORNADO 2 Series, Инструкция по эксплуатации и техническому обслуживанию

Страница: 11 / 32

9
TORNADO 2
English
OFF (0) OFF (0)
ON (I)
H
CLEANING AT THE END
OF THE WORK
• Reduce pressure to the minimum ( turn counterclockwise the
pressure control knob ( H1 ) ).
• Press the switch ( H2 ) placed on the box of the electric motor,
to stop the equipment.
• Open the safety valve to release the pressure in the circuit.
• Lift the suction pipe and replace the product tank with that
of the solvent (
ensure it is compatible with the product being
used) .
• Unscrew the gun nozzle ( do not forget to clean it with sol-
vent ).
• Press the switch (H2) ON (I) and turn a little the pressure
control knob (H1) clockwise so as the machine works till
the motor starts.
• Make sure the solvent recycles the washing fl uid from the
return tube.
• Close the safety valve.
• Point the gun at the product tank and, keeping the trigger
pressed, release the remaining product till a clean solvent
comes out. Now, release the trigger.
• Lift again the suction pipe and remove the solvent tank.
• Now point the gun at the solvent tank and press the trigger
so as to recover the residual solvent.
• As the pump starts idling, press the switch OFF (0) to
stop the equipment.
• In case of long storage, we recommend you to suck and
to leave light mineral oil inside the pumping group and the
fl exible hose.
Follow the washing procedure before using again
the equipment.
I
ROUTINE MAINTENANCE
CHECK ON THE PACKING NUT
Daily check the packing nut is tight in order to avoid wastes but
not excessively to prevent the piston from seizing and the
gaskets from wearing.
• For tightening, use the wrench ( I1 ) supplied ( ref. 11503 ).
ALWAYS DISCONNECT THE POWER SUPPLY
AND RELEASE THE PRESSURE IN THE PUM-
PING GROUP (open the drain valve) BEFORE
TIGHTENING THE PACKING NUT.
• Use the lubricant ( I2 ) supplied ( rif. 16325 ) to allow an easy
sliding of the piston inside the gasket group.
Daily top up the packing nut.
H1
Oil ring
I1
H2
I2