7
STORM 5
English
WASHING OF THE NEW EQUIPMENT
•
The equipment has already been adjusted at our factory with
light mineral oil left inside the pumping group as protection.
Therefore, wash with diluent before sucking the product.
•
Lift the suction pipe and dip it into the solvent tank.
•
Ensure the gun (
F5
) is without nozzle.
• Press the switch (
F6
) of the equipment
ON
(I)
.
•
Turn clockwise the pressure control knob (
F7
) so as the
machine works at idle speed.
• Point the gun at a container keeping the trigger pressed (
so
as to drain the oil inside
) till a clean solvent comes out. Now,
release the trigger.
• Remove the suction pipe and take away the solvent tank.
•
Point the gun at the solvent tank and press the trigger so as
to recover the residual solvent.
• As the pump idles, press the
OFF
(0)
switch to stop the
tooling.
Absolutely avoid to spray solvents indoors. In
addition, it is recommended to keep away from
the pump in order to avoid the contact between
the solvent fumes and the electric motor.
•
Now the machine is ready. Should you use water paints,
besides the solvent wash, a wash with soapy and then clean
water is suggested.
•
Insert the gun trigger lock and assemble the nozzle.
PREPARATION OF THE PAINT
• Make sure the product is suitable to be used with a spray
gun.
• Mix and filter the product before using it. For filtration, use
CLOSE-MESH
(
ref. 214
) and
LARGE-MESH
(
ref.215
)
LA-
RIUS METEX
braids.
Make sure the product to be used is compatible with
the materials employed for manufacturing the equi-
pment (
stainless steel and aluminium
). Because of
that, please contact the supplier of the product.
Never use products containing halogen hydrocarbons (
as methy-
lene chloride
). If these products come into contact with aluminium
parts of the equipment, can provoke dangerous chemical reactions
with risk of explosion.
F5
F6
ON (I)
OFF (0)
F7
Содержание Storm 5
Страница 1: ...ENGLISH OPERATING AND MAINTENANCE INSTRUCTION OPERATING AND MAINTENANCE INSTRUCTION ...
Страница 2: ......
