BT-accessories-xxx
After 10 seconds
Soft reset
PWR emits a steady green
light.
STATUS emits a steady
red light
After 25 seconds
Cancel
PWR emits a steady green
light.
If a teach-in could not be performed properly, although the device is ready for use and the STATUS value is
calculated and predicted, it is not actually correct.
LEDs for operating modes
Ready to use
PWR and STATUS emit a steady
green light. Wi-Fi is blue according
to the operating state.
Teach-in / initialisation
PWR emits a steady green light,
STATUS flashes green (approx. 1 Hz,
duration approx. 1 min).
Cable maintenance
required
PWR emits a steady red light,
STATUS flashes red (approx. 1
Hz).
Incorrect teach-in
PWR flashes alternately in red/green
(approx. 1 Hz, unlimited duration until
a HARD RESET or TEACH-IN is
carried out).
Cable defective
PWR emits a steady green light,
STATUS emits a steady red light.
No teach-in carried out
PWR emits a steady green light.
Short version of technical data
1
Wi-Fi interface
(PM02TWA only)
Type
IEEE802.11b/g/n
Frequency bands
EU 2.412 GHz - 2.472 GHz; channels 1-13
Maximum output power
max. 20.5 dBm
Transmission speed
802.11b: max. 11 Mbit/s
802.11g: max. 54 Mbit/s
802.11n: max. 150 Mbit/s (HT20,MCS0, MCS7)
Note:
We have checked the content of this document for consistency with the hardware and software described. However,
deviations cannot be ruled out, so we cannot guarantee complete consistency. That being said, the information contained in
this document is regularly updated. When using the purchased products, please refer to the latest version of the document,
which can be viewed and downloaded online at www.lappkabel.com.
1
See long version of data sheet available for download at www.
lapp
h
ungaria.hu/etherline-guard
LAPP HUNGÁRIA Kft.
•
2040 Budaörs
•
Neumann János u. 1
Tel. +36 23 501 250
•
