ML610Q102 Reference Board User’s Manual
3
4. Notes on use
(1) The information contained herein can change without notice owing to product and/or technical improvements.
Before using the product, please make sure that the information being referred to is up-to-date.
(2) Before using this board, read carefully and understand the contents of the ML610Q102 user's manual and the
uEASE user's manual.
(3) The engineering sample of ML610Q102 is mounted on the board.
Therefore, please confirm the characteristic finally by using MP of ML610Q102 and customer's mass production
boards.
(4) When you use uEASE, please set J1 jumper to the uE side.
(5) When a power supply is given from the exterior, please be given by pin4 of CNU2 connector and set J2 jumper to
the USR side.
(6) When you set J2 jumper to the USR side and uEASE is connected, please turn ON the power supply of a board
before starting uEASE.
Moreover, please stop uEASE before turning off the power supply of a board.
(7) When J2 jumper is set to the uE side, the power supply capacity of uEASE. is +3.3V/100mA.
(8) This board has a conductivity pattern in the back, therefore it may short-circuits when it is used having put on the
existing conductive component.
5. Reference schematic:
The reference schematic of this reference board is shown below.
RESET_N
TEST
PB0
PB1
PB2
PB3
PA2
VPP
PA0
PB7
VDD
VSS
PB6
PB5
PB4
PA1
1
2
3
4
5
6
7
8
16
15
14
13
12
11
10
9
1
2
4
6
7
9
10
3,5,8
CNU2
0.01u
4.7u
1
2,5,8
3
6
7
9
10
CNU1
13
2,4,6,8,10,12
7
3
5
CNUE
4
ML610Q102
USR
uE
C2
C3
USR
uE
C1
0.1u
J2
J1
1
9,11,14
<fig.2 Reference schematic>
