Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
Fixing Instructions
Specification
Voltage:
240V 50Hz
Lamp:
Max. 1 x 40W E27 GLS
IP rating:
44
Make sure you have the following items which
are required to install this light fitting:
• Selection of cross and flat head screwdrivers.
• Electric drill and assorted drill bits.
• Wire strippers.
• Insulation tape.
This is a Class 1 product and must be earthed.
This product is only suitable for connection to a
240V~50Hz supply in accordance with current IEE
wiring regulations. It should be installed in accordance
with local building regulations.
This product is IP44 rated and is suitable for outdoor use.
Before installing your light fitting always switch off
the mains supply and remove the appropriate fuse
or switch off the appropriate circuit breaker before
commencing installation.
This product contains glass so care must be taken
when fitting or handling to prevent personal injury or
damage to the product. If replacing an existing fitting,
make a careful note of the connections.
This product is suitable for installation on surfaces
with normal flammability e.g. wood, masonry. It is not
suitable for use on highly flammable surfaces or in
flammable atmospheres.
Never put anything on the product or hang anything
on any part of this product.
Never fit bulbs of a higher wattage than those specified
on the label, as these may cause overheating and
damage the fitting. This product is dimmable when
used with a dimmable bulb.
If you are in any doubt about your competence please
consult a qualified electrician.
If any modification is made it will invalidate the warranty
and may render the product unsafe.
Keep children and animals away from the assembly area.
This fitting contains small parts that could cause
choking if swallowed.
Keep all plastic wrapping materials away from children
to avoid danger of suffocation.
Ensure that all packaging is disposed of carefully
and responsibly.
Decide on the position of the light fitting, or remove
existing light fitting. Note the position of the electrical
connections. Ensure there is a solid mounting surface,
preferably a brick wall, to support the weight of the
light fitting.
• Remove the outer bezel
(1)
and shade
(2)
by
removing the screws around the outside of the
products. Keep screws safe for refitting later.
• Using the wall back as a template mark the position
of the fixing holes and drill them.
• Take care to avoid damaging any concealed wiring
and pipes. The correct fixings should be used for
brick, cavity walls or plasterboard.
• Pierce a hole in the grommet, and pull the cable
through. Remove the cover in front of the terminal
block
(3)
and wire as detailed below.
• Fix the wall back into position.
Installation
Check that...
• You have correctly identified the house wires.
• The connections are tight.
• No loose strands have been left out of the
connection block.
• Earth cable is securely attached to earth connection.
Wiring
Having correctly identified the wiring from your existing
light fitting, pull the wire through the hole. Add supplied
sleeving to live and neutral cables and connect to the
terminals inside the product in the following way:
Live and neutral cable to lampholder terminals and
earth cable to earth screw.
L
N
Sleeving
1
2
3
L
N
Sleeving
L
N
Sleeving
