Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
Fixing Instructions
Specification
Voltage:
240V 50Hz
Lamp:
Max. 1 x 60W E27 GLS
IP rating:
44
Make sure you have the following items which
are required to install this light fitting:
• Selection of cross and flat head screwdrivers.
• Electric drill and assorted drill bits.
• Wire strippers.
• Insulation tape.
This is a Class 1 product and must be earthed.
Please read these instructions carefully before
commencing any work, and retain for reference.
Install in accordance with IEE Wiring regulations
and current Building Regulations.
To prevent electrocution switch off at mains supply
before installing or maintaining this fitting. Ensure other
persons cannot restore the electrical supply without
your knowledge. If you are in any doubt, please consult
a qualified electrician.
This light fitting should be connected to a circuit
with a 30mA RCD fitted.
When changing a bulb, always switch off at the
mains and allow the old bulb to cool before handling.
Dispose of used bulbs carefully and responsibly.
Do not exceed the wattage stated or use a different
shape bulb as indicated on the fitting. This product
is not suitable for dimming.
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
This product is rated at IP44. It is not suitable for
location in or near a marine or sea environment.
• Remove the back box
(4)
by undoing the finials
(1)
from the threaded bolts.
• Use the back box as a template and mark and make the
holes, making sure the back plate is correctly aligned so
that the threaded bolts are horizontal.
• Bring the mains cable through the rubber grommet,
then use appropriate fixings
(3)
to secure the back box
to the wall.
• Unscrew the cap
(7)
and retain the two side screws
(6)
.
• Fit the bulb
(8)
.
NOTE: Never fit bulbs of a higher
wattage than those specified on the label as these
may cause overheating and damage the fitting.
Refit the cap, ensuring the seal is tight. There are two
indents to ensure the cap is aligned correctly.
Installation
Layout
• Decide on the position of the light fitting, or remove
existing light fitting. Note the position of the electrical
connections. Ensure there is a solid mounting surface,
preferably a brick wall, to support the weight of the
light fitting.
• Refit the lamp over the 2 threaded bolts in the back plate
and secure with the rubber washer and finials
(1)
.
Take care not to trap or strain the internal cables.
• Turn on the power and test. The PIR sensor settings
(9)
can be altered by turning the dials under the fitting
marked ‘SENS’ and ‘TIME’.
Commissioning
Check that...
• You have correctly identified the house wires.
• The connections are tight.
• The cable entry grommet is securely in place to ensure
that the water ingress protection is maintained.
• The Terminal Block is wrapped and wiring is overlapped
both sides with 2 layers of insulation tape.
Wiring
Having correctly identified the wiring from your existing
light fitting, pull the wire through the hole and connect
to the connection block
(5)
inside the product in the
following way:
NEUTRAL
EARTH
SWITCHED LIVE
BLUE (N)
GREEN/YELLOW or
METALLIC EARTH CONNECTION
BROWN (L)
HOUSEHOLD SUPPLY
LIGHT FITTING
4th BLOCK PROVIDED FOR LOOP
TERMINATION IF NECESSARY
N
L
N
L
Max.8M
105°
1-
2M
~
1.
7M
LUX
9min
8sec
2
2
2lux
2000lux
T
6
8
3
4
5
1
9
2
7
