lap 2617S-PIR, Инструкция по сборке и эксплуатации, Страница: 2 / 7

6. Do not attach any other products or decorations to the lamp.
7. Do not use the luminaire in rooms and adverse surroundings where flammable
gases, vapours, or dusts exist or might exist.
8. In order to prevent fire and eye damage observe following:
- Do not look directly into the light source.
- Keep the luminaire away from flammable materials.
9. Cut the power supply completely and provide a safeguard to prevent reconnection
in case of damages of any kind, particularly in wet conditions when safe operation
is no longer ensured.
10. While using the lamp in commercial areas, additional regulations may apply.
11. Service and maintenance shall be carried out only by specialists under usage of
original replacement parts.
12. This luminaire gets hot whilst in operation. Do not install within reach of children.
Page 2 of 7
Before you start
1. Check the pack and make sure you have all of the parts listed above. If not,
contact your local LAP store who will be able to help you.
2. Decide on an appropriate location for your spotlight (see Siting Instructions below).
3. This product is not suitable for single-handed installation. An assistant will be
required during fitting.
4. If you are in any doubt about installing or assembling this product, consult a
qualified electrician.
Siting Instructions
1. This product is designed with only alternating power supply voltage connection of
220-240V / 50Hz and only use the type of bulb specified (see section "Technical
Data").
2. The Lamp is designed for outdoor use, and it is weatherproof.
3. The light is rain and splash-proof (IP44).
4. IP degree of protection is guaranteed only when properly mounted.
5. For safety reasons, using metallic components of buildings or furniture as a power
conductor is strictly forbidden.
6. Do not modify or redesign the product.
7. Different use than described above might damage the product. Moreover, it can
create hazards, such as short circuit, fire, electrical shock, etc.
8. The safety instructions and technical data must be observed strictly.
Safety Instructions
1. Installation should only be done by a qualified electrician who is familiar with the
associated risks and regulations!
2. Before connecting the device, ensure that the rated voltage and current as
indicated on the data plate match your mains supply.
3. This lamp is a Class I product and must be connected to earth.
4. Make sure that the power supply is switched off before mounting, servicing,
cleaning and maintenance.
5. During all works on the luminaire, wearing conductive jewelry like chains,
necklaces, or rings made of metal is prohibited.