ⓒ
2019
LaON
Technology Co., Ltd. All rights reserved.
15
Beltpack setup and pairing
When you operate each Beltpack for the first time with the Mobile Station, you must pair up the Beltpack with a
Mobile Station. This pairing process allows a Mobile Station and a Beltpack to recognize each other and an own
cryptic code will be given for the corresponding system. The Mobile Station will identify all the paired up
Beltpacks and recognize the difference between the Beltpacks. If a Beltpack is added or replaced later, the new
one is necessarily to be paired up with the Mobile Station.
Each Mobile Station allows up to one hundred twenty eight(128) Beltpack connections.
Beltpack setup
Before pairing up the Beltpack with the Mobile Station, set up all Beltpacks as following steps:
Slide the cover down to open the battery cover (#10), and put a fully charged rechargeable battery pack (BAT50
or BAT50R) or battery sled with two fresh AA 1.5V alkaline batteries. Make sure the position of polarity (+, -) is
correct. Close the battery cover.
Pair Beltpacks
Check out the
power status of the each Beltpack
’s, which will be paired up with Mobile Station. To execute a
paring process, the Mobile Station and Beltpacks should be turned on. Beltpacks should not go further than 3
feet (1 meter) from the Mobile Station while they are being paired.
NOTE
: Once paring is completed, the Mobile Station and each Beltpack should go further than 6.5 feet (2
meters) to operate otherwise, there could be audio breakups.
Ready to pair with Beltpack
Turn on the Beltpack by pressing PWR button for 2 seconds and confirm the Normal menu is displayed. When a
Beltpack is not paired up yet, the LED adjacent to the Talk button will be flash red.
Pair Beltpack to Mobile Station
⚫
Confirm the Normal screen of the Mobile Station is displayed on the OLED screen. If the screen is in a sleep
mode, press Set to wake it up. On Mobile Station, press and hold the Set button on the front panel just after
pressing and holding the Power (PWR)
button. By doing this, the Mobile Station will be in ‘pairing waiting
mode’ and the message, ‘Pairing…’ will appears shortly on the Mobile Station display and then you can
release both buttons. In the Pairing wait mode, Mobile Station waits a pairing requirement from the Beltpack
for 20 seconds, and during this time all communications between Beltpacks will be halted.
⚫
Make sure that the Beltpack to pair is displayed on the Normal screen. Otherwise press Set to wake it up
from the sleep mode and stay not further than 3 feet (1 meter) from the Mobile Station. Press and hold the
Set button on the front panel just after pressing and holding the Power (PWR) button. By doing this, the
Beltpack
will also be in ‘pairing processing mode’ and the message, ‘Pairing…’ will shortly appears on the
Beltpack display and then you can release both buttons.
The first time each Beltpack is paired to a Mobile Station, each ID number of the Beltpack is generated
sequentially.
9
10
11
1
4
2
7
3
5
6
8
