Lanzar VIBE530P, Руководство пользователя

Страница: 6 / 14

www.Lanzar.com
6
OPERATIONS
Setting system volume
1. Turn the master volume and subwoofer level controls to their minimum settings.
2. Turn the source unit on and increase the volume until you hear distortion.
3. Reduce the volume to just below the distortion point (approximately 80% of
full volume). This is the maximum usable musical signal for the source unit.
Turning the volume beyond this point increases noise and distortion without
increasing the musical signal.
Note:
Once you set the source unit volume, do not change it. Always use the volume
control on the VIBE530P as the master (main) volume control. The VIBE530P has
better electronics, a higher sound to noise ratio, and is more linear than the
volume settings on any source unit available.
Adjusting the Controls
The VIBE530P provides a graphic adjustment band for each of four frequency
ranges: sub,low, mid, mid-high and high frequency. You can adjust the center
of each frequency band to fine tune the acoustical response to your vehicle's
interior.
1. Set all frequencies to the center position.
The small dot on the control knob should be set at 12 o'clock.
2. Play your favorite music track and adjust the individual controls to suit your
taste. Avoid extreme settings, which can distort musical peaks.
3. Increase or decrease the equalizer gain controls to suit your taste.
4. If your system includes a subwoofer, slowly increase the subwoofer level until
you hear a solid bass.
5. If your system includes rear speakers, adjust the fader control to add rear sound.
Set it so most of the music comes from the front and only fills the rear.
Setting the low-pass frequency
Set the low pass frequency switch on the top of the VIBE530P to either 60Hz or
90Hz depending on the subwoofer and subwoofer amplifier requirements.