www.Lanzar.com
10
Mark the location for the mounting screw holes
by positioning the amp where you wish to install it and use a scribe
(or one of the mounting screws) inserted in each of the mounting holes to mark the mounting surface.
If the mounting surface is carpeted, measure the hole centers and mark with a felt tip pen.
Before attempting to drill the mounting holes, take note of any wires, lines or other devices in your vehicle
which may be Iocated behind the mounting surface!
Then drill pilot holes in the mounting surface for the mounting
screws and insert them. Tighten the screws securely.
When making electrical connections to your amplifier, please observe the following:
•
Use at least 8 gauge wire for power and ground connections.
•
Wire the amplifier directly to the car battery.
•
For the ground connection, use the shortest possible wire to a good chassis ground point.
•
Wire the remote connection to the auto start lead of your head unit, equalizer or power antenna.
About Power Fuses:
Lanzar Vector amplifiers
feature built-in fuse systems. These fuses protect both the amplifier and electrical system in
your vehicle from fault conditions. If you ever need to replace the fuse in your amplifier, use a fuse of exactly the same
type and rating. A different type or rating may result in damage or fire.
