Power Connections
Connect the ground terminal to the closest point on the chassis of the vehicle.
Keep this ground wire to less than 39" (100 cm) inlength. Use
8
gauge
(or heavier) wire.
Connect the remote terminal to the remote output of the head unit using 16
gauge (or heavier) wire.
Connect an empty fuse holder within 1
8
" (45 cm) of the car battery, and run
8
gauge (or heavier) cable from this fuse to the amplifier location. Then
connect the fuse holder to the "BATT+" connection on the subwoofer rear panel.
POWER
�
FUSE
8
CJ
Battery
Remoter Level Control Connection
lnstal the remote control securely under the
dash or in a similar location where using it will
not distract the driver.
Chassis
7
gr ound
point
to REMOTE TURN-ON
terninal of head unit
Remote
Level Control
VCTBS10
Owner's Manual-6
Mounting the subwoofer
1. Find a suitable location in the vehicle in which to mount the amplifier.
A typical location is shown below:
2.
Make sure there is sufficient air circulation around the intended mounting location.
3.
Mark the location for mounting hole screws by positioning the cabinet where you
wish to install it. Make a small mark to identify the position and remove the unit.
Thoroughly clean the area you plan to attach the subwoofer, using a vacuum cleaner.
Then attach the supplied double adhesive tape, and put the subwoofer in the place
and press down on it securely.
Troubleshooting
If you experience operation or performance problems with this product, compare your
installation with the electrical wiring diagram on the previous pages. If problems
persist, read the following troubleshooting tips which may help eliminate the problems.
PROBLEM
POSSIBLE REASON
SOLUTION
• N0+12v to
po.Ne!"
wire
• Check fuses and connections to battery
Not switching on. Power
•
No po.Ne!"
to remote wire
• Check remote on connections to head unit
LED not 'on'
• Fuse
broken
• Replace fuse with correct type and
amperage
•Fuse bloNn
• Replace fuse with correct type and
Not working, but status
amperage
LED 'on'
• Move unit to vented area
•Amplifier too
hot
• Tum head unit down
No sound
•Head Unit
• Check heed u n i t vo lume level
• Gain
control not
set up
• En sure you have s e t up the amplifier
gain level control
•
Connedions
• Check all power, remote on and ground
connections
