www.Lanzar.com
5
Installation
Mounting Precautions
This in-dash EQ can be mounted next to the source unit or under the dash with
the supplied mounting brackets. For easy set-up, mount the equalizer so the
front panel controls will be easily accessible for the driver's seat after installation.
In addition, observe the following precautions.
1. Check the clearance on both sides of a planned installation before drilling any
holes or installing any screws.
2. When routing RCA cables, keep them away from power cables and output
speaker wires.
3. Do not allow liquids or foreign objects to enter the unit.
4. If the unit should become wet, turn off all the power and call your local
authorized dealer so they can check for any possible damage.
Wiring Precautions
Read all of the following wiring precautions. If you are not sure about any of
the installation or wiring processes, please contact your local dealer for help.
1. This unit operates on an automotive 12V negative ground power source and
requires additional audio components for proper operation.
2. Disconnect the negative (-) lead of the battery before making any power
connections.
3. A good chassis ground connection is critical to the performance of your in-dash
EQ. Use the shortest ground wire possible and securely connect the car chassis
along with the source unit to minimize resistance and avoid noise problems.
4. Extra cable can cause signal loss and act as an antenna for noise.
Use only high quality RCA cables that are no longer than needed.
5. If you are using a source unit without a remote turn-on lead, the in-dash EQ
can be turned on with a switched accessory lead.