PremierWave® XC HSPA+ Intelligent Gateway User Guide
62
9: Action Settings
Actions can be configured for alarms and reports available in the PremierWave XC HSPA+
intelligent gateway.
Alarms and Reports
PremierWave XC HSPA+ intelligent gateway updates the action settings page to display and
configure the alarms. The following alarm and report actions are available in PremierWave XC
HSPA+ device:
eth0 link state change
wwan0 link state change
Digital input 1 state change
Digital input 2 state change
Device temperature change
Cellular temperature change
On scheduled reboot
Note:
One or more types of “action” can be configured and triggered when an event
occurs.
The “on scheduled reboot” alarm state will be on at the time of a scheduled reboot
and will remain on till the device actually reboots (in approximately 30 seconds). These
are not applicable for “on scheduled reboot” alarm: Email Alarm Reminder Interval,
Normal Email, Normal Message, Normal Reminder Interval, SNMP Reminder Interval,
SNMP Normal Message, and Delay.
Actions
contains the configuration options for all the alarms and reports listed above.
Table 9-1 Action Settings
Action Settings
Description
Delay
Use Delay to defer alarm processing.
Alarm actions will not be executed if the cause is corrected within this time.
Use Email to send an email to configured Email recipients.
If an
Alarm Email
profile number is selected, that email will be sent when the
alarm is turned on. The contents of
Alarm Message
will be placed into the email
body when an alarm email is sent. If the alarm stays on longer than the Reminder
Interval, another alarm email is sent.
If a
Normal Email
profile number is selected, that email will be sent when the
alarm is turned off. The contents of
Normal Message
will be placed into the email
body when a normal email is sent. If the alarm stays off longer than the Reminder
Interval, another normal email is sent.
