Lantronix Com Port Redirector, Руководство пользователя, Страница: 19 / 31

4
4
:
:
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
This chapter provides general guidelines for using the device server and Com
Port Redirector. It also describes how to set up Com Port Redirector and the
device server you will be using with it, and how to verify connectivity between the
two.
This chapter includes the following topics:
Topic Page
General Device Server Configuration Guidelines 4-1
General Com Port Redirector Usage Guidelines 4-2
Configuring a UDS, CoBox, XPort, or XPress Device 4-2
Configuring an MSS100 or MSS485-T Device Server 4-5
Configuring an MSS4 or MSS-VIA Device 4-7
Configuring an ETS Terminal Server or SCS Console 4-9
Configuring Port Settings 4-10
Verifying Connectivity with the Device 4-13
General Device Server Configuration Guidelines
Observe the following general guidelines when preparing the device server for
use with Com Port Redirector:
The device server to which Com Port Redirector will connect must have
an IP address.
The PC running Com Port Redirector must have a good network
connection to the device server.
If redirecting over a Wide Area Network (WAN), both the PC and the
device server must have a correct gateway address configured in their
TCP/IP settings.
All serial settings on the device server must match the settings of the
serial device. Serial settings include:
−
Baud rate
−
Parity
−
Stop bits
−
Flow control
−
Interface mode (RS-232 or RS-422/485)
Connect/Disconnect and Access Modes: The way the device server
accepts a connection must be configured appropriately to accept a
network connection from Com Port Redirector.
−
CoBox, UDS, XPort, and XPress products: set the connect mode to
C0 and the disconnect mode to 00.
Com Port Redirector™ User Guide 4-1