Lantronix CoBox-Micro, Руководство пользователя

Страница: 44 / 110

Setting the IP Address Getting Started
6-4
Serial Port Login
1 Connect a console terminal or PC running a terminal emulation program to the
Device Server’s first serial port (CH 1). The configuration serial port settings are
9600 baud, 8 bits, no parity, 1 stop bit.
2 To enter Setup (configuration) Mode, cycle the Device Server’s power (power off
and back on). After power-up the self-test begins and the red Diagnostic LED starts
blinking. You have one second to enter three lowercase “x” characters.
Note: The easiest way to enter Setup Mode is to hold down the “x” key at the
terminal while powering up the Device Server.
3
Select 0 (Server Configuration) and follow the prompts until you get to IP address.
4 Enter the new IP address.
5 Select 9 to save the configuration and exit Setup Mode.
The Device Server performs a power reset.
Using Another Device Server
To access another device server remotely, enter the SI command in Moniro Mode. Refer to
Appendix B which describes how to get to Monitor Mode. Refer to table B-1 which lists
all Monitor Mode commands.