14
Mounting Installation
DIN-Rail Mounting
The DIN-Rail bracket is screwed on the switch on the production line in the factory. If the
bracket is not screwed on the switch, please refer to
Figure-10
to screw it on the switch.
Follow the steps below to hang the industrial switch.
Figure-10: Rear side of the PoE Injectors Industrial Switch
1. Use the screws to screw the DIN-Rail bracket on the rear side of the industrial
switch.
2. To remove the bracket, reverse the step 1.
3. After the DIN-Rail bracket is screwed on the rear side of the switch, insert the top of
the bracket into the rail as
Figure-11
.
