Lanta Orion Link Batt 500, Руководство пользователя

Страница: 10 / 12

© Lanta Lighting™ 2016. Terms Apply. All trademarks are the property of their
respective owners. E&OE. All specifications and details are correct at time of print.
April 16 - Version 1
Owner Handbook Orion Link Batt 500™
5- Sound Active Mode
1. Press “MODE” button to select “Soud” to enter sound mode. Press “SETUP” and then
use the “UP” and “DOWN” buttons to adjust the sensitivity values SU01-SU31.
6- Static Colour Mode
1. Press “MODE” button to select “Colr” to enter a static colour. Each press of “SETUP”
will cycle through R/G/B255, and then you can adjust the values by the “UP” and
“DOWN”buttons.
7- Power Charging
Press “MODE” button to select “Chge” then “SETUP” to display the charge percentage
000 – 100.
The battery is an 11.1V, 2.6Ah Lithium Ion battery, which requires 2 hours to fully charge
and then will provide up to 6 hours operation depending on the mode set. When the
power switch is on the green LED’s will give a visual indication of power remaining.
100%-80%, 60%, 40%, 20% When remaining power is less than 20% the red LED will
flash.
Do not leave the battery discharged for long periods of time. To maximise battery life, it
should be recharged as soon as possible after use and every 3 months if not in regular
use.
In the event the battery requires attention, DO NOT attempt to remove it yourself. Refer
to your authorised Lanta Service Department.
8- Remote Control
The IR Remote will allow you to control your Lanta Orion Link Batt 500 without the need
for a controller.
Note – You will need to point the remote towards the receiver eye on
the front face of the light for it to work.
Press the “AUTO” button to set the light to run in Auto mode as described in section 2.
Press “AUTO” and then the “PRG” button to select the built-in programs. Use “+” & “-” to
select “Pr01” – “Pr09”.
When using built-in programs, press the “SPEED” button and then “+” & “-” to enter a
speed value setting between “SP05” & “SPFL”.