10
When the PoE LED is on, the port LED is indicating the power supply status.
LED
Status
Indication
Power
On
The switch is powered on.
Flashing
Power supply is abnormal.
Off
The switch is powered off or power supply
is abnormal.
System
On/Off
The switch works improperly
Flashing
The switch works properly.
PoE Max
On
The remaining PoE power
≤
7W.
Flashing
The remaining PoE power keeps
≤
7W
after this LED is on for 2 minutes.
Off
The remaining PoE power
≥
7W.
10/100/1000Mbps
Port LED
Green
On
The port is supplying power normally.
Flashing
The supply power exceeds the correspon-
ding port's maximum power.
Yellow
On
Overload or short circuit is detected.
Flashing Power-on self-test has failed.
Off
No PoE power supply is provided on the
port.
10/100/1000Mbps RJ45 Ports:
Designed to connect to the device with a
bandwidth of 10Mbps, 100Mbps or 1000Mbps. Each has a corresponding
1000Mbps LED.
Console Port:
Designed to connect with the serial port of a computer or
terminal for monitoring and configuring the switch.
SFP ports:
Designed to install the SFP module. LP-SGW2404FP switch
features some SFP transceiver slots that are shared with the associated
RJ45 ports. The associated two ports are referred as a “Combo” port,
which means they cannot be used simultaneously, otherwise only SFP
port works.
Note:
When using the SFP port with a 100Mbps module or a gigabit module, you
need to log on to the GUI (Graphical User Interface) of the switch and
configure its corresponding Speed and Duplex mode on
Switching
→
Port
→
Port Config
page. For 100Mbps module, please select 100MFD while select
1000MFD for gigabit module. By default, the Speed and Duplex mode of SFP
