4.1 Name and Function for Each Part of the Camera
Chapter 4 Function Introduction of Each Part
User's Manual | CA800 Series Embedded Camera
www.lanoptik.com
- 4 -
Switch to left: OFF ; the in Camera CA800 will stop working.
Switch to middle: USB Working mode. It will allow the in Camera CA800 connect to PC via USB cable.
Switch to right: WiFi Working mode. It will allow the in WiFi Camera Eyepiece connect to smart phones /
tablets via WiFi.
When the power is off, the red light is always on.
When switch to USB or WiFi working mode, the yellow light is always on.
When switch to USB working mode, the USB cable is used to transmission data to PC.
When switch to WiFi working mode, the USB cable is used to powered by USB power plug.
1.
Female interface:
connected with the eyepiece end of biological microscope.
2.
Fastening screws:
tighten the screws with the hexagon key to fix the eyepiece end of the biological
microscope.
3.
Male interface:
it is connected with the objective lens end of biological microscope.
4.
ACT indicator light:
when connect it via. WiFi, the blue light here flashes to start signal transmission.
5.
Power on/off:
6
.Power indicator:
7.
USB Cable:
8.
WiFi antenna:
enhance WiFi signal.
9.
Focusing screw:
turn the screw with hexagonal key to adjust the focal length.
10.
Reset hole:
the default settings can be restored by pressing with reset pin for 8-12 seconds.
