Lanner HCP-72i1, Руководство пользователя

Страница: 27 / 116

27
www.lannerinc.com
Chapter 4:
Hardware Installation
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING:
1. To avoid the risk of personal injury, electric shock, or
damage to the equipment, please remove all power
connections as well as all power sources.
2. Please wear ESD gloves to avoid potential injury or
damage.
Accessing the Components
1. Due to the hybrid architecture of HCP-72i1, you may
access the Upper Board or the Bottom Board. First, locate
the rear lock-handles and lock-screws. There should be 2
pairs on each side: two for the Upper Board and the other
two for the Bottom Board.
2. To access the Bottom Board, loosen the two lock-
screws and then pull the two lock-handles.
3. Pull the blade out while holding the lock-handles.
4. To return the bottom blade to its original place, simply
push it to the end and use the two lock-handles and lock-
screws to secure it.
5. To access the Upper Board, use the same method from
Step 2 and 3.
6. Pull the top blade out while holding the lock-handles.