Langmatz basic plus EK523, Руководство по эксплуатации

Страница: 19 / 28

19
9.6 Replacing the tactile pedestrian crossing symbol
Description of the tactile pedestrian crossing symbols for the visually
impaired DIN 32981
1 Crossing with additional
signalling request
2 Crossing only
(factory-fitted)
3 Crossing with central island
4 Crossing with level crossing
5 Crossing in two directions
A more detailed description of the symbols
and their functions is specified in
DIN 32981.
Fig. 19
Installation of the tactile pedestrian crossing symbol
•
Open the brackets (2) with the special
key (1) (as described in chapter 9.5).
•
Press the tactile pedestrian crossing
symbol (3) in slightly and click it out of
place.
•
Fully pull out the tactile pedestrian
crossing symbol downwards.
Note: The crossing symbol is spring-
loaded. Catch the spring when pulling it
out!
Fig. 20
•
Insert the new tactile pedestrian
crossing symbol (2)
•
Turn the tactile pedestrian crossing
symbol in the required direction.
Note: The fitted spring must not fall
out!
•
Remove the special key (1) .
•
Release the tactile pedestrian crossing
symbol and click it back into place.
Note: Check the built-in seal (3) for
correct fit.
•
Close the device again.
Fig. 21
1
2
3
4
5
2
1
3
1
2
3