Langer & Laumann TSG V4, Инструкция по установке и эксплуатации

Страница: 30 / 84

30
7.6 Manual mode / manual travel
To select Manual mode, choose parameter P1. The display appears. Turn the jog wheel anticlockwise
(c.c.w.) until the display appears. Pressing the jog wheel and holding it down moves the door in the open
direction. Turn the jog wheel clockwise (c.w.) until the display appears. Pressing the jog wheel and holding
it down moves the door in the closed direction.
When you release the jog wheel the door stops.
Select the display and press the jog wheel to exit manual mode.
NOTE:
Travel while Manual mode is active corresponds to the same drive response as when Door
Open or Door Closed signals are present on terminal X1.1 or X1.2.
As long as the operator is in manual mode, no control signals are accepted at terminal strip X1.1 and X1.2. If
the pressure function is activated (h3=03), this function can be executed by applying the input signal at X1.3
and simultaneous manual movement in the closed direction.
If an external sensor, two-channel, parameterized (hA=05) and connected, its input signal has priority over the
manual mode.
If the stop function is activated during manual mode, manual mode is terminated.
If an error occurs in manual mode, manual mode is terminated. The manual mode cannot be reactivated until
the error has been eliminated.
NOTE:
If the TSG is to be moved again over the entire control signals at X1, manual mode must be
terminated.
NOTE:
As long as the operator is in manual mode, the LED10, LED11 and LED12 continue to indicate
the applied control signals (see Chapter 16.1Overview of TSG electronic / Page 66), however,
they are not executed, since manual mode has priority.
c.w. = clock wise
c.c.w. = counter clock wise