CART
A
HOIST
™
GEN. 2
®
STEP 12 Strap Installation
Special Instructions:
Prepare hardtop for removal by removing all hardware, washer fluid lines, electrical, bolts,
and any latches. For good resources on removing your top watch videos on you-tube, make sure to reference
your specific model of Jeep as removal varies from year to year.
First begin by lifting your hardtop and blocking it up securely so it won’t fall and smash your fingers (Fig. 1).
Nothing sours taking your top off like a black thumbnail. Find those elevator bolts, and put them in the first
hole closest to the front of the Jeep (Fig. 2). Put a washer on top, then a 5/16 inch nut. Tighten this nut down
with a 1/2 inch wrench, tighten until the bottom of the elevator bolt is all the way flush (Fig. 3). Put the strap on
through the grommet with the loop facing away from the top (Fig 4-5). Thread on the wingnut until grommet
is secure. Put the strap over the top of your hardtop and repeat the step again on the other side. Do not twist
the strap.
Locate parts
:
Top removal strap (
HAC-066) & Elevator bolts, washers, and wingnuts (BAG-047)
Fig. 1
Fig. 2
Fig.4
Fig.5
Fig. 3
Page 13
