Lang ECCO-C, Установка, эксплуатация и обслуживание

Страница: 7 / 16

5
MANUAL OVERRIDE Located below the control panel, behind the louvered access door. In the
event of a computer failure, this switch takes control of the oven away
from the computer and directs the temperature control to a manual
thermostat located next to the switch.
BACK-UP THERMOSTAT Activated when the MANUAL OVERRIDE switch it set to ON. This
thermostat controls the oven temperature in the event of a computer
failure.
STATUS READOUT DISPLAY
The STATUS READOUT informs the operator
of the oven's status.
It can be used as a countdown timer, shelf in use
or internal oven temperature display during the
cooking cycle (see seperate PROGRAMMING
instructions).
The STATUS READOUT display informs the
operator when the oven is ready to bake, or if the
oven is above or below the progroammed
temperature.
Below is a list of displays and their definitions:
" " The oven is energized and ready for an operator command.
" " Stands for PREHEAT. A product has been selected and the oven is
heating to the set temperature.
" " The oven's internal temperature is below what is programmed.
" " A product change has been made and the oven's internal temperature is
above what is programmed.
" " A product selection has been made after the oven has preheated and the
computer is asking which shelf the product is placed on.
" " There is a fault in the control system, the computer will not operate until
service is performed.
" " Stands for CONTINOUS. The oven has been programmed without a time
being entered. The oven will operate continuously at the programmed
temperature.
"
" An entry has been made during the programming which is outside the
parametes of the computer.
PRODUCT AND SHELF BUTTONS
Once the PRODUCT BUTTONS are
programmed, all of the oven's operation is
controlled by the computer.
To select a product simply push any of the
programmed PRODUCT BUTTONS which is
labeled for the product you wish to cook.
Once a product button is selected, the oven will
preheat to the preprogrammed temperature.
The control will not allow the operator to select a
shelf until it has reached its programmed
temperature.
Once the programmed temperature is reached the
STATUS READOUT will display "
" and
the beeper will sound briefly.
Only the PRODUCT BUTTONS programmed at
the oven's temperature will now be activated (the
button lamp will be on).
To cook, place the product into the oven cavity
and shut the oven doors. Select the PRODUCT
BUTTON labeled for that product.