Lang CLSH-E, Установка, эксплуатация, обслуживание и устранение неисправностей, Страница: 8 / 16

8
INITIAL START UP
5.1 Initial Start-up
Before the initial use of the Salamander, the unit must be wiped down thoroughly
with a dry rag to remove any oils used in manufacturing. Note: There may be a
small amount of smoke from the unit for the first couple of hours of use. This is
the result of manufacturing oils burning off and not cause for alarm.
OPERATION
CAUTION:
ALWAYS KEEP THE AREA NEAR THE APPLIANCE
FREE FROM COMBUSTIBLE MATERIALS.
CAUTION:
KEEP FLOOR IN FRONT OF EQUIPMENT CLEAN AND
DRY. IF SPILLS OCCUR, CLEAN IMMEDIATELY, TO
AVOID THE DANGER OF SLIPS OR FALLS.
6.1 Salamander Controls
The controls are located on the front, right side of the unit. There is one three-
position control knob. The settings are: Low, High and Off.
The Salamander rack is adjustable. There are four rack positions available. To set
the position, put the product on the rack, push the lever down and forward into one
of the positions.