2M-W358;
ACCU-TEMP
Spark Ignition Gas Griddle
2M-W358;
ACCU-TEMP
Spark Ignition Gas Griddle
6
EQUIPMENT DESCRIPTION
Exterior Construction
The griddle dimensions are 17” (43.18cm) High, 30” (76.20cm) Deep, and width is dependent on the
actual model number.
The Sides, Bottom, and Rear wall are constructed of double wall stainless steel, which allows closer
installation to combustible surfaces.
The stainless steel drop-down door keeps the controls cool and control area clean.
The griddle surface is made of 1” thick, highly polished steel to reduce hot and cold spots, recovery
problems, warping, and ensure even heat to the edges of the griddle.
Controls
The ACCU-TEMP Thermostat Control Griddles comes include:
• An Electronic ignition, main power switch & power indicator for the entire unit.
• Snap-action thermostats
• Each twelve-inch section of the griddle is controlled independently.
Technical
• Griddle operates on either Natural gas or Propane.
This must be specified when ordering. It is shipped with a Power Cord and Plug attached.
• Floor space required is 30” (76.20cm) Deep, and width is 2 ft, 3ft, 4ft, 5ft, or 6ft depending on actual
model number.
• The griddle weighs 260, 390, 520, 650, 780 lbs. depending on actual model number.
Griddle Gas and Voltage Specifications
The Lang Model can be connected to any 120 Volt source.
The gas and electrical specifications are listed in the table on the previous page.
NOTICE
The data plate is on the right side of the griddle. The oven voltage,
wattage, serial number, wire size, and clearance specifications are
on the data plate. This information should be carefully read and
understood before proceeding with the installation.
Legs
IL2465
Gutter
1” Griddle Surface
Section
Dial Temp
Grease
Pan
Power
Indicator
Main
Power
Switch
Gas
Regulator
(not shown)
