In this configuration the TT amplifier is a slave device ,its setting being called up by the midi controller. This midi controller
could be a device which purely generates midi information or a multi effects pedal board. To setup the amplifier you need to do
the following:-
1.
Select the required patch on your pedal board/midi controller
2.
Select the Channel/Volume/Reverb switch setting on your TT amp.
3.
Press and hold the Store button. (for about 2 seconds)
The next time your select that patch - the setting of the Channel/Volume/Reverb switches
will be recalled. Repeat steps 1>3 for each of your favourite patches. So for all your
favourite sounds, your pedal board can assign a TT amp state. The TT amplifier
will respond to 127 different program changes. Some FX processors have
separate midi pedal board controllers which they remotely phantom power.
Your TT amplifier is compatible with this system as it passes phantom power
from the Midi In socket to the Midi Thru socket. If you have quite a selection
of midi effects toys you can combine the two
applications. Useful recommendations in doing so
are:
1.
Daisy chain the Midi out to Midi in from the
midi controller to the TT amp, as shown in
application 2.
2.
Connect the next cable from the TT amps Midi
Thru to the next devices Midi In repeat step 2 until
you get to the end of your chain of toys.
Laney
OPERATING INSTRUCTIONS
Page 14 /24
MIDI APPLICATIONS NOTE 2: TT AMPLIFIER AND MIDI CONTROLLER
M
id
i T
hr
u
FX
S
en
d
FX
R
et
ur
n
FS6 Footswitch
Midi In
M
id
i O
ut
Midi Controller
....Midi Patch 1 .---,-
M
id
i O
ut
Further Possibilities
H
/T
T1
H
TT
50
00
