TUBE AMPLIFIER SURVIVAL TIPS
V1
V2
V3
V4
V5
V6
V7
Page
12 / 16
Laney
•
Tube amplifiers
;
generally sound much warmer/sweeter than solid state transistor amplifiers but they also need a little more respect
due to the fragile glass tubes themselves. The LC50-112 uses top quality tubes, which should give you years of trouble free service, however
like all tube amps; it is important to treat it with a certain amount of care.
•
Tubes are fragile glass components;
they can easily be damaged if thrown in and out of vehicles,
•
Make sure the impedance;
of your cabinets matches the setting on your amplifier. Improper impedance matching will result in
reduced output power output and compromised sound at best and amplifier failure/premature tube failure at worst.
•
Allow the amplifier;
to warm up to room temperature before switching it on, The sudden thermal shock generated can crack the
cold glass tube housing plus any moisture is bad news around high voltage electronics.
•
Allow the amplifier;
to cool down after playing before moving. Hot tubes are more susceptible to damage than cool ones.Use good
quality loudspeaker leads, cheap leads are often not up to the job of handling the large requirements for loudspeakers and can often short out.
•
don't like running into a
circuit. A tubes life expectancy is based upon a number of factors which include
operating temperature, how hard and how often it is played, vibration due to travel etc. Tubes should be changed in your amplifier if you
notice any change in your amplifiers performance etc. They need not be changed at any regular interval.
•
Typical problems;
with preamp tubes can be a crackly noise, hiss, hum and microphony. The preamp tubes can safely be changed with
no action required if they fail or reduce in performance. Typical output tube problems can be blown HT fuse; sound lacking in punch, sound
lacks extreme highs or lows and low level hum. The Output tubes can be replaced singularly if you replace them with the exact same type
AND grade as factory fitted otherwise they should be replaced as a quad set. See the diagram following to see how to check the tube grade
fitted. Exact replacement preamp tubes and matched sets of output tubes are available from Laney via your dealer.
•
To change a tube;
switch off the unit and unplug from the mains supply. Wait for the tubes to cool down. Lay amplifier down on its
front face and remove the protective grille held in place with four screws. You should now be able to access the underside of the amplifier
chassis. Preamp tubes
can then be gently pulled out. Take care when pushing the
new tube in to make sure the pins are all aligned properly.
Tube amplifiers
;
open
have a spring retainer which must be pulled away, the tube
The output tubes have a spring retainer fitted to the tube socket which grips the
base of the tube. The tube must be released from this by pushing the retaining clips down with one hand, whilst gently rocking and pulling the
tube from its socket with the other. Take care when pushing the replacement tube past the retaining clips to ensure that the rib on the base of
the tube is aligned in its locating slot in the socket.
•
;
Amplifier connection
In order to avoid damage, it is advisable to establish and follow a pattern for turning on and off your
equipment. With all system parts connected, effects processors etc.
BEFORE
turning on your guitar amplifier.