Laney AudioHub AH110, Руководство пользователя

Страница: 10 / 16

9
CH 1 CH 2 MIX OUT
CLIP POWER
CH 3
AUX IN
5
4
3
2
1
0 10
9
8
7
6
5
4
3
2
1
0 10
9
8
7
6
5
4
3
2
1
0 10
9
8
7
6
LINE
LEVEL LEVEL LEVEL
MIC
LINE
MIC
CH 1 CH 2
MIX OUT
VOLUME
TREBLE
BASS
5
4
3
2
1
0 10
9
8
7
6
5
4
3
2
1
0 10
9
8
7
6
5
4
3
2
1
0 10
9
8
7
6
MASTER
L Z B 1 2 3 4
MAXIMUM POWER CONSUMPTION
160 WATTS 50/60Hz
~110V/~120V
~220V/~240V F2.5A L 250V F3.15A L 250V
SUPPLY VOLTAGE & FUSE RATING
1/2. CH1 & CH2: Mono Input channels.
3. LEVEL: Use the Level control to set the channel volume..
4. LINE INPUT: an unbalanced input - for higher output line level devices eg. - keyboard, processor,
drum machine.
5. MIC INPUT: A balanced input for low level, low impedance devices eg. -mic (200-600ohms) or
electro-acoustic guitar.
6. CH3 LEVEL: Use this control to adjust the level of the onboard USB/SD player or an external
(line level) signal feed connected to the AUX IN.
7. AUX IN: This gives you the option to connect an additional line level device. Control the Level
with Level control . Please use a stereo cable.
8. MIX OUT: A BALANCED signal feed that is picked up before the power amp stage. This can be
used to connect to a second AudioHub cab (daisy chained), active wedge monitor, house PA or
mixing console for example.
9. POWER LED: This will illuminate when the unit is powered up. There is also a second power LED
on the front of the cab which will illuminate to indicate that power is present.
10. CLIP LED: Illuminates just before the amplifier begins to clip. Adjust the level controls and signal
level from your source so this illuminates only briefly on peaks in the music.
11. MASTER VOLUME: Controls the overall level of your AudioHub.
12. Active BASS and TREBLE: These controls allow you to boost or cut the low/high frequency
response of the amplifier.
13. HEAT SINK: Cooling fins for the amplifier. Do not obstruct.
14. MAINS SWITCH: Turns the system on and off. Ensure the level controls are at minimum
when switching on and off.
15. INFORMATION: Area relating to the amplifier: Serial Number, operational information, power rating, etc.
16. MAINS INLET SOCKET AND FUSE: IEC input for connection of an appropriate mains lead. Only replace fuse with the type indicated for your
mains voltage.
Setting the mains voltage:
The Voltage selection is made via the fuse holder.
To change the voltage, slide out the fuse holder and rotate to achieve the correct voltage selection for your country.
Note :
Pay special attention when selecting the voltage because incorrect voltage assignment could cause damage to your AudioHub!
14
Rear Panel Controls
1 2
3
8
7
6
5
4
9 10
11
12
13
14
15
16