Landoll Weatherproofer III 2310 Series, Руководство оператора

Страница: 36 / 80

3-14 F-556-0910 Edition
ASSEMBLY INSTRUCTIONS
4. Lift front gangs up under frame and install 1-7/16 x
6-3/8" pin on inner mount with roll pins
(See
Figure 3-9.)
5. Attach pivot block and orientate as shown so the
flanges are to the top and bottom. Slide gang from
the rear of the outer gang mounts into the front
position.
6. Install the bushing and 1-8 x 6 hex head cap screw
and hex lock nut at the rear of the gang mount to
secure the gang assembly.
IMPORTANT
Make sure the hex lock nut is located on top of the
gang assembly.
7. Install roll pins into the pin, disc angle. The 4" roll pin
will just go through the pin to act as a handle. The 2"
roll pin will be centered in the pin.
Figure 3-9: Front Disc Gang Installation