Landoll Brillion SSP4, Руководство оператора

Страница: 24 / 34

3-8 7K555
OPERATION
Adjustment of the Wheel Track
Remover
The depth of the wheel track removers can be adjusted.
Loosen the (4) 1/2-13 X 1-1/4 bolts, and nuts that secure
the clamps to the coil tine supports. Adjust the supports
up or down to the desired depth and then retighten the
nuts on the bolts. Do this for each pipe and tine
assembly.
See Figure 3-8.
Figure 3-8: Wheel Track Remover
Roller Wheels
NOTE
Failure to locate the clamp band bolt over the weld will
cause the clamp band to loosen and slide.
Adjust the front roller wheels first. Loosen clamp bands
and slide the wheels snug against each other, centering
the entire assembly under the deflector shields. Locate
the bolt in the clamp band over the weld on the pipe.
Slide the clamp band against the end wheel and tighten
the clamp band bolt.
To adjust the rear roller wheels follow the front wheel
procedure. Start aligning the peaks of the rear wheels
with the valley of the front wheels at the center of the rear
roller. This will provide the best alignment of worn
wheels.
See Figure 3-9.
Figure 3-9: Roller Wheels
%ROW
[´
1XW´
Front
Rollers
Rear
Rollers
Axle
Clamps