Landoll Brillion SS4, Руководство оператора

Страница: 19 / 56

ASSEMBLY
7K555-2401 2-5
TABLE OF CONTENTS
Figure 2-6: 5-Strip Brush Agitator Orientation
Agitator Installation Steps
1. Remove the Cotter Pins from the RH end of the Seed
Shaft. See Figure 2-7.
2. On the right end of the Seed Box, remove the 5/16-18
Hardware that attaches the end bearing to the inside
of the Seed Box.
3. Slide the Seed Shaft out of the right end of the Seed
Box. Set aside the 7/8 Flat Washers, Square Bore
Bushing, and Seed Shaft.
4. Remove existing Agitators and Square Bore
Washers.
5. Orient if applicable and lay out the Agitators inside the
Seed Box. Place Square Bore Washers on each end
of the Agitators to prevent seed leakage and to
reduce Agitator end play between the Agitator
Bearings. Never force to add a Square Bore Washer
since it will cause binding. Agitators must be free to
rotate.
6. Place the set aside 7/8 Flat Washers on the end of the
Seed Shaft.
7. Place the set aside Square Bore Bushing on the Seed
Shaft. Reinstall the Seed Shaft aligning the Square
Bore Bushings, Square Bore Washers, and Agitators
inside the Seed Box.
8. Reinstall the end Bearing to the inside of the Seed
Box with 5/16-18 Hardware.
9. Check to be sure agitators rotate freely.
10. Push two 7/8 Flat Washers against the Square Bore
Bushing exposing the Seed Shaft inner hole. Install a
Cotter Pin in the Seed Shaft.
See Figure 2-8.
11. Push the end 7/8 Flat Washer against the inside of the
Frame End Plate and install a Cotter Pin in the
exposed Seed Shaft hole.
12. If 5-Strip Brush Agitators were installed, apply
Important Decal 5D505 to the front of the Seed Box in
a place visible by the tractor driver.
See Figure 2-9.
Figure 2-7: Agitator Installation
Figure 2-8: Agitator Installation Detail
Figure 2-9: Agitator Decal
ROTATION
REAR
5-Strip
Brush
Shifter
Plate
Nut,5/16-18
Lock Washer,5/16
Bolt,5/16-18
x 1-1/4
Square
Bore Bushing
Flat Washer,7/8
Cotter Pin,5/32
x 1-1/2
Seed Shaft
Flat Washer,7/8
Seed Shaft
Flat Washer,7/8
Flat Washer,7/8
Cotter Pin,5/32 x 1-1/2
Frame
End Plate
End
Bearing
Square
Bore Bushing
DISENGAGE CLUTCH (IF SO
EQUIPPED) OR RAISE SEEDER
BEFORE BACKING UP. FAILURE
TO DO SO WILL DAMAGE
BRUSH AGITATORS.
IMPORTANT
5D505