Landoll Brillion SS16, Руководство оператора

Страница: 34 / 100

2-16 F-1021-0422
TABLE OF CONTENTS
Basic Clutch Switch Box
Assembly - Optional
Assembly instruction for models with an installed Clutch.
1. Connect Clutch Cable Assembly to the Clutch
Connector and route along Frame and Drawbar/3-PT
Hitch. Secure to Frame and Drawbar/3-PT Hitch or
with Hydraulic Hoses and Warning Lamp Harness
with tie wraps.
See Figure 2-14.
2. Install Clutch Switch Box on Tractor in a convenient
location with the Hook and Loop included or other
type of mount (not included).
See Figure 2-13.
3. Connect 3-Pin Power Plug to 12 Volt Tractor
Convenience Outlet.
4. Check Electric Clutch Operation. The Electric Clutch
will engage when power is applied. (Clutch will make
a clicking sound). Set Seeder on the ground and drive
a short distance while turning Toggle Switch to “Seed”
and “No Seed”. The Seed Shaft will stop rotating
when Toggle Switch is turned to “No Seed” Position.
Electric Clutch Attributes:
• The Electric Clutch is controlled by a Toggle Switch
on the Clutch Switch Box that is mounted to the
Tractor.
• The Electric Clutch is engaged when power
(12 Volts) is applied.
• The Clutch Switch Box contains a 5 Amp Time-Delay
Fuse.
• The Electric Clutch must be disengaged (power off)
when Seed Shafts are turned manually for
Calibration
.
Figure 2-13: Switch Box
Figure 2-14: Clutch Harness
Toggle
Switch
Switch Box
Power Plug
Clutch
Connector
Clutch Cable
Assembly
Clutch
Transmission
Clutch Connector